Heat Pump Not Heating? Heat Pump Repair in Sandy, UT

Heat pump not heating in Sandy? Here is what to look for before you call for heat pump repair.

Outdoor heat pump unit beside a house, heat pump not heating repair in Sandy, UT

Heat Pump Not Heating in Sandy Homes

More Sandy homeowners are adding heat pumps, often paired with a gas furnace as backup. When a heat pump is not heating, these are the usual causes.

Stuck in defrost or iced over

Some frost on the outdoor coil on a cold morning is normal, and the unit melts it off on its own. A coil that stays solid ice points to a defrost sensor, control board or low refrigerant.

Reversing valve problems

If the heat pump blows cool air in heat mode, the reversing valve or its solenoid may not be shifting.

Thermostat setup on dual-fuel systems

The thermostat decides when to hand off to the furnace. A wrong setting can leave the heat pump struggling on the coldest nights.

Need help? Call for heat pump and HVAC repair in Sandy, or see furnace repair if your backup furnace is the problem.

Heat Pump Not Heating Questions in Sandy

Do heat pumps work in Sandy winters?

Modern cold-climate heat pumps keep heating well below freezing. Many Sandy homes pair one with a gas furnace for the coldest stretches.

Why is steam coming off my heat pump?

That is usually the defrost cycle melting frost off the outdoor coil. It should stop after a few minutes.

Furnace or AC Acting Up in Sandy?
Heating and cooling repair across the south valley.
Call (385) 614-7514